Merchant Monerod / DONE

Monero CLI Wallet: You must have monerod (blockchain node) installed to configure this module Quick installation: Monero Node / DONE

Monero's official page: https://www.getmonero.org/downloads/#cli

Supported currencies

• Monero XMR

Configuring the module

1. Go to Merchant & API -> Merchant system

2. Go to Monero Node (monerod) module settings

3. Fill in the Config section of this module Node RPC URL (monerod) - ip:port to monero-wallet-rpcservice example 127.0.0.1:18082 Node RPC Username - user name for authorisation to the RPC Node RPC Password - password for RPC authorisation Example configuration node --rpc-login monero:rpcPassword where monero is the username and rpcPassword is the password Node RPC Wallet - wallet name (if it does not exist, it will be created automatically) Node RPC Wallet password - it is important to write down your wallet password as it will not be shown to you again and if you forget it, you will lose access to your funds. Wait confirms blocks - the number of confirmations to be expected in order to mark the application as paid

Important! Make a note of the Wallet password you have set, your password is not displayed again after saving and if you lose this password you will not be able to recover it and therefore you may lose access.